DOT Push-In FittingsDOT Male Adapter
Brass + Plastic · Tube 1/8 …
View product →Home / Products / DOT Push-In Fittings / DOT Union Tee

Built and tested to DOT requirements (FMVSS 571.106 / SAE J844) for vehicle air brake systems, featuring easy push-to-connect assembly. These fittings are specifically designed for North American commercial vehicle applications.
The Union Tee — DOT Push-In Fittings is a Brass + Plastic fitting from the DOT Push-In Fittings range. A union tee joins three tube ends with no threaded port: one supply in, two lines out. It is used to split an air line mid-run, for example where a single supply must feed two consumers and there is no valve port to branch from.
In a truck or trailer air brake circuit, this union tee is used where a line is split mid-run with no valve port — for example at a reservoir outlet, where stored air feeds a relay valve. On a North American Class 8 tractor and semi-trailer the same fitting is used on the service and emergency air lines between tractor and trailer, including the red and blue coiled lines at the gladhand connection.
Fitting the Union Tee: To fit it, cut the nylon tube square, push it fully home into the collet until it seats, then pull it back to check it is locked. To remove it, press the release and pull the tube out. No spanner is needed on the tube side.
The Union Tee — DOT Push-In Fittings belongs to the DOT Push-In Fittings range. Material: Brass + Plastic. Category tube sizes: 1/8 · 5/32 · 3/16 · 1/4 · 5/16 · 3/8 · 1/2 · 5/8 · 3/4. Category thread sizes: NPT / G 1/8 · 1/4 · 3/8 · 1/2. Built to FMVSS 571.106 / SAE J844 for North American vehicle air brake systems. The DOT push-in range in the factory catalogue is rated from vacuum to 250 psi, -40°F to +200°F, for tube outside diameters from 1/8 in to 3/4 in with NPTF threads. The range is a replacement for Parker Legris DOT push-in fittings.
Category range, not per-model data: the sizes above are the DOT Push-In Fittings range as published. The exact tube size, thread size and dimensions of the Union Tee — DOT Push-In Fittings are confirmed against the factory catalogue when you inquire — send the part number, or the tube and thread you need, and we quote the exact model.
Most buyers add the matched PA12 tubing, truck cables & coiled air lines or EBS lines to the same order — one quote, one shipment.
See companion lines →
DOT Push-In FittingsBrass + Plastic · Tube 1/8 …
View product →
DOT Push-In FittingsBrass + Plastic · Tube 1/8 …
View product →
DOT Push-In FittingsBrass + Plastic · Tube 1/8 …
View product →
DOT Push-In FittingsBrass · Tube 1/8 …
View product →