Get a Quote

Home / Products / DOT Push-In Fittings / DOT Male Branch Tee

DOT Male Branch Tee — DOT Push-In Fittings, product photo
DOT Push-In Fittings

DOT Male Branch Tee

Built and tested to DOT requirements (FMVSS 571.106 / SAE J844) for vehicle air brake systems, featuring easy push-to-connect assembly. These fittings are specifically designed for North American commercial vehicle applications.

Category
DOT Push-In Fittings
Material
Brass + Plastic
Tube sizes
1/8 · 5/32 · 3/16 · 1/4 · 5/16 · 3/8 · 1/2 · 5/8 · 3/4
Thread sizes
NPT / G 1/8 · 1/4 · 3/8 · 1/2
Application
Heavy-duty truck and trailer

Key Features

  • Built to DOT FMVSS 571.106 / SAE J844 requirements (DOT range)
  • High-pressure resistance
  • Corrosion-resistant materials
  • Easy installation and maintenance
  • Wide temperature operating range

About the Male Branch Tee

The Male Branch Tee — DOT Push-In Fittings is a Brass + Plastic fitting from the DOT Push-In Fittings range. A branch tee takes the branch off the side of the main run. The through line keeps its direction while a second line is fed from the side, so a supply can be tapped at any point along its route without breaking the main line.

Where it fits

In a truck or trailer air brake circuit, this male branch tee is used where a supply must be tapped mid-route — for example at a reservoir outlet, where stored air feeds a relay valve. On a North American Class 8 tractor and semi-trailer the same fitting is used on the service and emergency air lines between tractor and trailer, including the red and blue coiled lines at the gladhand connection.

Fitting the Male Branch Tee

Fitting the Male Branch Tee: To fit it, cut the nylon tube square, push it fully home into the collet until it seats, then pull it back to check it is locked. To remove it, press the release and pull the tube out. No spanner is needed on the tube side.

Sizes and standard

The Male Branch Tee — DOT Push-In Fittings belongs to the DOT Push-In Fittings range. Material: Brass + Plastic. Category tube sizes: 1/8 · 5/32 · 3/16 · 1/4 · 5/16 · 3/8 · 1/2 · 5/8 · 3/4. Category thread sizes: NPT / G 1/8 · 1/4 · 3/8 · 1/2. Built to FMVSS 571.106 / SAE J844 for North American vehicle air brake systems. The DOT push-in range in the factory catalogue is rated from vacuum to 250 psi, -40°F to +200°F, for tube outside diameters from 1/8 in to 3/4 in with NPTF threads. The range is a replacement for Parker Legris DOT push-in fittings.

Category range, not per-model data: the sizes above are the DOT Push-In Fittings range as published. The exact tube size, thread size and dimensions of the Male Branch Tee — DOT Push-In Fittings are confirmed against the factory catalogue when you inquire — send the part number, or the tube and thread you need, and we quote the exact model.

Complete the circuit

Most buyers add the matched PA12 tubing, truck cables & coiled air lines or EBS lines to the same order — one quote, one shipment.

See companion lines →
Call +86-17825829635
Keep looking

Related products