DOT Push-In FittingsDOT Male Adapter
Brass + Plastic · Tube 1/8 …
View product →Home / Products / DOT Push-In Fittings / DOT 45 Degree Male Elbow

Built and tested to DOT requirements (FMVSS 571.106 / SAE J844) for vehicle air brake systems, featuring easy push-to-connect assembly. These fittings are specifically designed for North American commercial vehicle applications.
The 45 Degree Male Elbow — DOT Push-In Fittings is a Brass + Plastic fitting from the DOT Push-In Fittings range. An elbow fitting turns an air line through 45 degrees — a gentler change of direction than a 90-degree elbow, for places where a full right angle would strain the tube. It is used where a tube must leave a valve or reservoir at an angle and run along a chassis rail without being bent sharply or kinked.
In a truck or trailer air brake circuit, this 45 degree male elbow is used where a line must turn at a port — for example at a reservoir outlet, where stored air feeds a relay valve. On a North American Class 8 tractor and semi-trailer the same fitting is used on the service and emergency air lines between tractor and trailer, including the red and blue coiled lines at the gladhand connection.
Fitting the 45 Degree Male Elbow: To fit it, cut the nylon tube square, push it fully home into the collet until it seats, then pull it back to check it is locked. To remove it, press the release and pull the tube out. No spanner is needed on the tube side.
The 45 Degree Male Elbow — DOT Push-In Fittings belongs to the DOT Push-In Fittings range. Material: Brass + Plastic. Category tube sizes: 1/8 · 5/32 · 3/16 · 1/4 · 5/16 · 3/8 · 1/2 · 5/8 · 3/4. Category thread sizes: NPT / G 1/8 · 1/4 · 3/8 · 1/2. Built to FMVSS 571.106 / SAE J844 for North American vehicle air brake systems. The DOT push-in range in the factory catalogue is rated from vacuum to 250 psi, -40°F to +200°F, for tube outside diameters from 1/8 in to 3/4 in with NPTF threads. The range is a replacement for Parker Legris DOT push-in fittings.
Category range, not per-model data: the sizes above are the DOT Push-In Fittings range as published. The exact tube size, thread size and dimensions of the 45 Degree Male Elbow — DOT Push-In Fittings are confirmed against the factory catalogue when you inquire — send the part number, or the tube and thread you need, and we quote the exact model.
Most buyers add the matched PA12 tubing, truck cables & coiled air lines or EBS lines to the same order — one quote, one shipment.
See companion lines →
DOT Push-In FittingsBrass + Plastic · Tube 1/8 …
View product →
DOT Push-In FittingsBrass + Plastic · Tube 1/8 …
View product →
DOT Push-In FittingsBrass + Plastic · Tube 1/8 …
View product →
DOT Push-In FittingsBrass · Tube 1/8 …
View product →